How to install your 2022+ WILDTRAK CARGO RAILS

How to install your 2022+ WILDTRAK CARGO RAILS onto your Next-gen Ford Ranger or Raptor

DON'T HAVE SET? YOU CAN FIND THEM HERE IN NEW ZEALAND! CLICK HERE

We see so many posts about people asking how to install the Wildtrak Cargo Rails and have absolutely no idea or reference to guide them! 

Hopefully these pictures & info will serve as a reference to help 

For Ranger Models Sport, XLT, XL, XLS, RAPTOR

STEP 1: Fitting the inner Cargo Rails. Locate the 4x brackets as in the photo below. 2x left & 2x right . Locate the 2x Rails marked L & R. Make sure the end brackets are fitted as seen in the photo. The rails should come with 22x 7mm bolts as seen in the photo below.

NOTE: If you do not have them or do not wish to fit them please skip to the next step of fitting the roller shutter.

STEP 2: Fit the 2x front brackets 1x left & 1x Right using 1x T40 and 3x 7mm bolts.  

NOTE: Please note how the shutter cable is placed and insure it is not pinched by the bracket or the T40 bolt when the bracket is fitted. 

STEP 3: Place the middle brackets 1x left & 1x right with 4x 7mm bolts. 

STEP 4: Place the rails into place and hand screw in the rear T40 and the remaining 7mm bolts. Do not tighten until all the bolts are in their place. Once all in tighten the  1x T40 and then the rest of the 7mm bolts. Now place the plastic caps over the bolt holes. 

STEP 5: You can now fit the 4x Grab handles onto the inner rails. Pull the latch with your two fingers and then slide into the opening and drag them into place. Release the latch and lock them into place.